Everything below concerns cyclic heptapeptide. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-03-31. Where a claim depends on a specific study, the study is described rather than over-claimed.
Regulatory status varies by jurisdiction, and the substance is frequently described as unapproved for therapeutic use. Some authorities classify it alongside prescription-only medicines or controlled categories, while others address it through general consumer protection rules. Analytical surveys have reported mismatches between label claims and measured content in products sold online, although the scope of such testing is limited. Whether these discrepancies are widespread remains an open question. Discussion in the literature therefore tends to combine chemistry, supply-chain observation and policy analysis.
The material is commonly handled as a lyophilized powder in sealed vials. The solid dissolves readily in water and in polar organic solvents, producing a clear solution after reconstitution. Light, heat and repeated freeze-thaw cycles are the concerns most often raised in handling guidance, because peptide bonds and the constrained ring can degrade. Working solutions are generally prepared fresh, and material left in solution is treated as less stable than the dry form. These properties shape how laboratories store and aliquot reference material.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry. Retention time supports identity, while the mass spectrum confirms the molecular weight of the intact peptide. Purity is frequently reported as a percentage of total peak area, a figure that depends on the wavelength, column and gradient used. Impurity profiling may also look for truncated sequences, oxidised forms and residual counterions. Amino acid analysis and peptide mapping provide orthogonal confirmation when required.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
Melanotan-2 is a synthetic linear peptide built from seven amino acids arranged in a short chain. Its sequence is commonly written as Ac-Nle-Asp-His-D-Phe-Arg-Trp-Lys-NH2, which includes a modified N-terminus and an amidated C-terminus. The molecule belongs to the melanocortin family and acts as a receptor agonist. Structural features such as the D-phenylalanine residue and the Nle substitution are associated with increased stability against enzymatic degradation relative to the natural parent peptide.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid in a sealed vial |
| Solubility class | Soluble in water and polar organic solvents | Reconstituted solutions are generally clear |
| Typical storage temperature | -20 degrees Celsius or below, dry | Protect from light; avoid repeated freeze-thaw cycles |
| Common analytical methods | Reversed-phase HPLC-UV, LC-MS | Used for purity estimation and mass confirmation |
| Reported purity range | Area percentage above 95 percent | Reporting practice and acceptance limits differ by laboratory |
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
The peptide acts as a non-selective agonist at melanocortin receptors, showing affinity for MC1R, MC3R, MC4R and MC5R. Activation of MC1R on melanocytes drives the conversion of tyrosine into melanin and shifts production toward the darker eumelanin form. MC4R signalling in the central nervous system is linked to appetite and energy balance, which helps explain why reduced food intake appeared in early human studies. Effects on MC4R and on vascular tone also account for the erectile responses recorded as unexpected findings in those same trials.
Melanotan-2 is frequently confused with afamelanotide, a linear analogue authorised in the European Union for erythropoietic protoporphyria. The two compounds differ in chain length, ring structure and receptor selectivity, so findings for one cannot be transferred directly to the other. Published controlled human data on melanotan-2 remain sparse, and much of what circulates online derives from small studies or unpublished reports. Questions about effect size, dose-response behaviour and long-term safety therefore remain unresolved.
Melanotan-2 is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence incorporates a lactam bridge that constrains the peptide into a ring, which increases resistance to enzymatic breakdown relative to the natural hormone. Researchers at the University of Arizona synthesised the compound in the late 1980s and early 1990s while studying pigmentation pathways. It has never received marketing approval from any national medicines regulator. In the scientific literature it is usually described as a laboratory research reagent rather than a therapeutic product.
Identity testing for a cyclic peptide of this size usually relies on reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The mass spectrum confirms molecular weight, while the chromatographic trace indicates the proportion of related impurities. Tandem mass spectrometry can provide sequence-level information when fragmentation data are compared against a reference standard. Nuclear magnetic resonance is sometimes used to confirm the lactam bridge, although it requires more material and greater operator expertise than routine chromatographic methods.
Lyophilised peptide powder is comparatively stable when kept dry, cold and protected from light. Once dissolved, the molecule is exposed to hydrolysis, oxidation and microbial growth, and degradation accelerates at higher temperatures and in alkaline solution. Repeated freeze-thaw cycles concentrate solutes and promote aggregation. Handling guidance for research peptides commonly clusters around freezer temperatures for powder and short refrigerated use for reconstituted solutions, with pH control and sterile technique applied throughout.
Verification of a purchased sample requires documentation linking a batch to a certificate of analysis, and that document should be read for the methods used rather than the headline purity figure. A single chromatographic percentage does not establish identity. Independent laboratories can perform identity and content assays, but no such test establishes that a product is suitable for human use. Claims about efficacy rest largely on small, early studies rather than on replicated controlled trials, and that gap remains open.
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Melanocytes are the pigment-producing cells of the skin, and they carry melanocortin-1 receptors on their surface. When the receptor is activated, cyclic adenosine monophosphate rises inside the cell and raises the activity of enzymes such as tyrosinase, which increases melanin output. Melanotan-2 binds melanocortin-1 receptors in vitro and in animal models, and this binding is generally described as the basis for the tanning effect. Other receptors account for different effects: melanocortin-4 receptors contribute to appetite and erectile signalling, while melanocortin-3 and melanocortin-5 receptors contribute to energy balance and exocrine function.
Early published reports described melanotan-2 as a tanning agent without sun protection, which means darkening is not the same as protection against ultraviolet radiation. Later studies explored the peptide in erectile dysfunction, hemorrhagic shock, and some skin conditions. No regulator in the United States or Europe has approved it for clinical use. Many products labelled melanotan-2 are sold without approval and their identity and purity are unverified. Its long-term safety in humans remains an open question.
Jung saw the human psyche as "by nature religious" and made this idea a principal focus of his explorations. His influence on the "psychologization of religion", spirituality, and the New Age movement has been immense.
== Primary chloroplast lineages == All primary chloroplasts belong to one of four chloroplast lineages—the glaucophyte chloroplast lineage, the rhodophyte ("red") chloroplast lineage, the chloroplastida ("green") chloroplast lineage, and the amoeboid Paulinella chromatophora lineage. The glaucophyte, rhodophyte, and chloroplastidian lineages are all descended from the same ancestral endosymbiotic event and are all within the group Archaeplastida.
== Databases == Large scale identification of PPIs generated hundreds of thousands of interactions, which were collected together in specialized biological databases that are continuously updated in order to provide complete interactomes. The first of these databases was the Database of Interacting Proteins (DIP). Primary databases collect information about published PPIs proven to exist via small-scale or large-scale experimental methods. Examples: DIP, Biomolecular Interaction Network Database (BIND), Biological General Repository for Interaction Datasets (BioGRID), Human Protein Reference Database (HPRD), IntAct Molecular Interaction Database, Molecular Interactions Database (MINT), MIPS Protein Interaction Resource on Yeast (MIPS-MPact), and MIPS Mammalian Protein–Protein Interaction Database (MIPS-MPPI).< Meta-databases normally result from the integration of primary databases information, but can also collect some original data. Prediction databases include many PPIs that are predicted using several techniques (main article). Examples: Human Protein–Protein Interaction Prediction Database (PIPs), Interlogous Interaction Database (I2D), Known and Predicted Protein–Protein Interactions (STRING-db), and Unified Human Interactive (UniHI). The aforementioned computational methods all depend on source databases whose data can be extrapolated to predict novel protein–protein interactions. Coverage differs greatly between databases.
MD simulation of the full satellite tobacco mosaic virus (STMV) (2006, Size: 1 million atoms, Simulation time: 50 ns, program: NAMD) This virus is a small, icosahedral plant virus that worsens the symptoms of infection by Tobacco Mosaic Virus (TMV). Molecular dynamics simulations were used to probe the mechanisms of viral assembly. The entire STMV particle consists of 60 identical copies of one protein that make up the viral capsid (coating), and a 1063 nucleotide single stranded RNA genome. One key finding is that the capsid is very unstable when there is no RNA inside. The simulation would take one 2006 desktop computer around 35 years to complete. It was thus done in many processors in parallel with continuous communication between them. Folding simulations of the Villin Headpiece in all-atom detail (2006, Size: 20,000 atoms; Simulation time: 500 μs= 500,000 ns, Program: Folding@home) This simulation was run in 200,000 CPU's of participating personal computers around the world. These computers had the Folding@home program installed, a large-scale distributed computing effort coordinated by Vijay Pande at Stanford University. The kinetic properties of the Villin Headpiece protein were probed by using many independent, short trajectories run by CPU's without continuous real-time communication. One method employed was the Pfold value analysis, which measures the probability of folding before unfolding of a specific starting conformation. Pfold gives information about transition state structures and an ordering of conformations along the folding pathway.
Sources: en.wikipedia.org
=== Inositol depletion hypothesis === Lithium treatment has been found to inhibit the enzyme inositol monophosphatase, involved in degrading inositol monophosphate to inositol required in PIP2 synthesis. This leads to lower levels of inositol triphosphate, created by decomposition of PIP2. This effect has been suggested to be further enhanced with an inositol triphosphate reuptake inhibitor. Inositol disruptions have been linked to memory impairment and depression. It is known with good certainty that signals from the receptors coupled to the phosphoinositide signal transduction are affected by lithium. Myo-inositol is also regulated by the high affinity sodium mI transport system (SMIT). Lithium is hypothesized to inhibit mI entering the cells and mitigate the function of SMIT. Reductions of cellular levels of myo-inositol results in the inhibition of the phosphoinositide cycle.
== Synthesis == In the synthesis of melanotan II, an ε-amino group of lysine and an γ-carboxy group of aspartic acid have their orthogonal protection removed before undergoing a carbodiimide mediated lactamization, leading to an intermediate. This intermediate, when attached to N-acetylnorleucine, forms melanotan II. The entire process can be accomplished in 12 steps with an overall yield of 2.6%, and the product is more than 90% pure without preparative chromatography.
Fatty acid synthesis starts with acetyl-CoA and builds up by the addition of two-carbon units. Fatty acid synthesis occurs in the cytoplasm of cells while oxidative degradation occurs in the mitochondria. Many of the enzymes for the fatty acid synthesis are organized into a multienzyme complex called fatty acid synthase. The major sites of fatty acid synthesis are adipose tissue and the liver.
Sources: en.wikipedia.org
The dry powder is more stable during transport and storage than a solution. It also allows a known amount of material to be reconstituted at a chosen concentration.
Most certificates state a percentage derived from chromatographic peak area, alongside a mass confirmation. The exact criteria and acceptance thresholds vary between laboratories.
Dry powder is kept frozen or refrigerated and protected from light and moisture. Solutions are handled cold and used promptly to limit degradation.
No. Melanotan-2 is manufactured synthetically. The naturally occurring peptide in the same family is alpha-melanocyte-stimulating hormone, which the body produces as part of normal endocrine and neural signalling.